AL-KO TWIN 10000 combi, Manual

Page: 17 / 106

Protect from frost
Your pump is susceptible to low temperatures. Make sure to empty the pump of residual liquid
and store it so that it is protected from frost.
Disposal
The device must not be included in household waste, but rather, it must be disposed
of professionally. The appliance, its packaging and accessories are all produced from
recyclable materials and must be disposed of accordingly
.
Malfunctions
!
Before you attempt to remedy any malfunction of your pump, pull the plug to prevent injury
or death due to electrocution!
What is wrong? What is the possible reason? How to remedy the malfunction:
Motor does not run. Impeller is blocked. Remove blockage in inlet area.
Clean the impeller with a jet of
water.
Thermal switch has switched off. Wait until the thermal switch has
automatically turned the pump on
again. Check water temperature.
Have the pump checked.
No power. Have a qualified electrician check
the power supply.
Float switch does not work even
though liquid is above cut-in level.
Send pump to your nearest
AL-KO service centre.
Submersible pump runs but
is not pumping out liquid.
Air is trapped in the pump hous-
ing.
Tilt the pump to let the trapped air
out.
Wait for a maximum of 3 minutes
until the air cushion has escaped
from the pump space.
In flat suction operation, switch on
an off briefly several times, if
necessary.
Suction slots are blocked.
Remove blockage and clean
suction slots.
Pressure line is blocked. Clear blockage in pressure line.
Pressure hose is bent. Straighten out pressure hose.
Pressure blockage Clear blockage
Submersible pump is only
pumping out liquid very
slowly or weakly.
Hose diameter is too small. Attach a hose with a larger diame-
ter.
Suction slots are blocked. Remove blockage and clean
suction slots.
Pumping height is too great. Lower pumping height.
If you are unable to remedy a malfunction, please call the AL-KO service centre nearest you.
Traducción del manual de instrucciones original
GB 4