GB
40
COMBI-CARE 36.8 E comfort
Maintenance and care
■
If the motor suddenly stops: The motor circuit
breaker has triggered due to an overload.
Wait a few minutes and then attempt to start
the motor again.
■
In the following cases, visit the customer ser-
vice workshop:
■
Motor no longer starts.
■
Appliance has moved onto an obstruc-
tion.
■
Appliance vibrates and does not run
smoothly.
■
The blades of the scarifier roller or steel
spring prongs of the aeration roller (op-
tional) are bent.
7
MAINTENANCE AND CARE
CAUTION!
Danger of cutting inju-
ries
There is danger of lacera-
tions when reaching into
the blade system while it is
running on or the stopped
blade system.
■
Stop the appliance and
wait until the blade sys-
tem has stopped.
■
Disconnect the mains
plug to power down the
appliance.
■
Wear protective gloves.
7.1
Cleaning the blade system
IMPORTANT!
Danger from water
Water in the appliance
causes short-circuits and
destroys electrical compo-
nents.
■
Do not spray the appli-
ance with water.
■
Only use a broom or a
brush for cleaning.
1. Stop the appliance and wait until the blade
system has stopped.
2. Disconnect the mains plug.
3. Remove the grass collector see
chapter 6.7
"Attaching and removing the grass collector
[optional] (11)", page 39
4. Tip the appliance onto the side and clean the
blade system with a broom or brush.
7.2
Replacing the scarifier roller and
aeration roller (optional) (13)
The scarifier roller is intended for coarse scarify-
ing work and the aeration roller (optional) for fine
scarifying work (see
chapter 2.3 "Scope of sup-
Removing the roller
1. Stop the appliance and wait until the blade
system has stopped.
2. Disconnect the mains plug.
3. Turn the appliance over.
4. Press the locking bar (13/1) until the lock is
released (13/a).
5. Fold the locking bar (13/1) upwards (13/b).
6. Gently push the roller (13/2) towards the
housing (13/c).
7. Remove (13/d) the roller (13/2).
Installing the roller
Proceed in reverse order.
