AL-Car BC 4535, User Manual

Page: 20 / 240

GB 9 Translation of original user instructions
8 STORING A UNIT
Failure to follow these steps may cause var-
nish to form in the carburettor and difficult
starting or permanent damage following stor-
age.
1. Perform all the general maintenance recom-
mended in the Maintenance Section of your User
Manual.
2. Clean exterior of engine, drive shaft assembly,
debris shield and stringhead.
3. Drain fuel from the fuel tank.
4. After fuel is drained, start engine.
5. Run engine at idle until unit stops. This will purge
the carburettor of fuel.
6. Allow engine to cool (approx. 5 minutes).
7. Using a spark plug wrench, remove the spark
plug.
8. Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber. Pull starter rope slowly several
times to coat internal components. Replace spark
plug.
9. Store unit in a cool, dry place away from any
source of ignition such as an oil burner, water
heater, etc.
10. Do not transport and store the trimmer with the
blade fitted unless the supplied transport guard is
also fitted.
9 REMOVING A UNIT FROM
STORAGE
1. Remove spark plus.
2. Pull starter rope briskly to clear excess oil from
combustion chamber.
3. Clean and gap spark plug or install a new spark
plug with proper gap.
4. Prepare unit for operation.
5. Fill fuel tank with proper fuel / oil mixture. See
Fuel and Lubrication Section.
10 TECHNICAL SPECIFICATIONS
FRS 4535
Engine type Air cooled 2-stroke engine
Displacement 42 cm³
Power: 1,25 kW
Dry weight 9,1 kg
Fuel capacity 1,2 l
Cutting width with twin line 41 cm
Line diameter 2,4 mm
Cutting width with cutting blade 25 cm
Handle „Bike”-handle
Ignition Electronic
Spark plug NGK BPMR6A or similar
Drive Centrifugal clutch
Vibration ISO 7916 ≤ 7,5 m/s
2
Sound pressure value EN 27917 102 dB(A)