4
Connect AL-Muakkita to a separated outlet with a circuit breaker exclusively used
for this purpose, do not connect it with a florescent light or an inductive load.
The operating voltage is
[110
~
220Vac, 50
~
60Hz]
, the power consumption is
10W
.
When connecting AL-Muakkita to the main power and nothing appear on the
displays after five seconds, do the following:
1.
Press the (
) key on the remote control.
2.
If nothing appeared, press the reset key (
) on the local keypad.
3.
If no response occurred after setp2, press the reset key (
) and the
adjustment key (
) simultaneously, release the (
) key first then the (
)
key, AL-Muakkita will operate and display the default time and date.
Default time: 12:00AM
Default date: 01
st
Jan. of the software version issuing year.
4.
Adjust the time and date by pressing the adjustment (
) key and follow
the instructions explained later.
If the time (clock) display is bugged (frozen), press the reset (
) key to refresh
it.
When the main power is off; the displays are all off, but the internal timing circuit is
still working by means of an internal battery, so AL-Muakkita doesn't need to be
readjusted even if the main power cut lasted one month.
Adjusting AL-Muakkita:
How to set the time and date:
Press and hold the adjustment key (
) for five seconds, the year digits
appear flashing on the date display.
Use the increase (
,
)/decrease (
,
) keys to set the year to the
required value then press (
,
), the month digits start flashing.
Use the increase (
,
)/decrease (
,
) keys to set the month (
1 ~ 12
),
then press (
,
), the day digits start flashing.
Set the day (
1~31
) in the same way then press (
,
), the time appears on
the clock display and the hour digits start flashing.
Set the hour then press (
,
), the minute digits start flashing.
set the minutes then press (
,
), pay attention to the
PM
light
indicator status which is located on the local keypad:
o
The time is PM when the indicator is on.
o
The time is AM when the indicator is off.
Press (
,
) to switch between AM/PM then press (
,
), the clock will
operate normally and the prayer times and the sunrise time appear on the
displays.
