Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
1.4. Now set the desired temperature switch-off point (0 ~ 85° C) with the stepless thermostat control dial (right-
hand knob). It is best to do this as follows: Turn the thermostat knob to the highest temperature (MAX.) and
let the heater run until your desired temperature value is reached. Now turn (adjust) the control downwards
towards the minimum until the heating function switches off automatically. Now leave the control dial
(thermostat) in this position and whenever it gets colder in the room, the heating rod automatically starts to
heat and when the adjusted temperature is reached again, the heating rod automatically switches off again!
Note: The fan of the heater is not controlled by the thermostat. If the selected target temperature is reached, the
heating element switches off automatically, but the fan continues to run !
2. Switch off
To switch off the unit, turn the stepless thermostat control knob (right-hand knob) to minimum (MIN) and let the unit
run in fan mode for about 5 minutes to allow it to cool down. Afterwards, also turn the operating strength
adjustment knob to "0" to switch off the unit completely.
3. Cleaning & Storage
Please always unplug the heater from the mains and allow it to cool down completely before carrying out any
cleaning activities on your heater !
3.1 Cleaning the housing:
-
Use a soft and damp cloth to clean the outside of the housing.
-
Use only mild cleaning agents to clean your heater and no aggressive cleaning agents, these can damage your
appliance !
-
Please make sure that no water gets inside your heater at any time !
3.2 Storage:
-
We recommend that you repack the unit in its original box for storage.
-
Store the heater in a dry and sufficiently ventilated place/space.
4. Other operating instructions
4.1. Do not disconnect the mains plug by pulling on the power cable !
4.2. Do not use insect repellent, oil spray, paint spray, etc. near the heater. This may cause damage to the unit or
even fire or explosion !
4.3. Do not place the appliance on sloping or uneven ground !
4.4. Please always keep a sufficient distance to the wall to avoid possible overheating of the appliance.
4.5. For an effective and economical heating operation, please close all doors and windows in the room of the
heater !
