Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
Instructions for use:
1. Commissioning
1.1. Insert the mains plug properly into the socket.
1.2. Switch the unit on at the main switch (see picture on the right). The unit then signals that it is
ready for operation by the operating light (lights up red).
1.3. By pressing the red operating light, you can switch the operation in the following sequence
(circuit):
Level 1 (900 Watt heating power)
> Operating light blue
Level 2 (1,200 Watt heating power)
> Operating light blue
Level 3 (2,100 Watt heating power)
> Operating light blue
Off (No heating power)
> Operating light red
2. Remote control
You can also control all settings and functions of your radiant heater with the remote control included in the
delivery. However, the main switch of the radiant heater must be switched on for this purpose. The remote control
requires a (CR 2450) button cell battery (not included) !
Make sure to control the upper part of the radiant heater with the remote control. The receiver for the remote
control is located at the height of the main switch. Therefore, the signal of the remote control cannot be received
from below (see example picture above).
ON / OFF switch
Heating element 1
(900 watt)
ON / OFF switch
Heating element 2
(1,200 watt)
