www.tmatlantic.com
4
system will display the actual temperature
①
and setting
temperature
②
in
℉
, and vice versa.
④
When the actual temperature on the soldering tip is less
than the set-point, “HEAT ON” will display and make the
soldering tip heating up.
⑤
When the absolute offset is more than ±10
℃
between the
actual temperature and the set-point on the soldering tip or
the nozzle, “WAIT” will display. It means that the temperature
electronic control system is not in the stable situation, we
should wait a moment to let the “WAIT” disappear.
⑥
When “ERROR” display, there may be a trouble on the
system, or the soldering iron is not connected to the control
system correctly.
3.3 Suspend Mode
The soldering station integrates automatic suspend function.
The station will go into suspend status if the soldering iron is
not operated in 15 minutes. The temperature of the soldering
tip will cool down to 200
℃
and keep it during the suspend
mode until the station is restarted. And the station will be
back to the previous working condition after restarted.
You can use the below methods to restart the soldering
station:
•
Power off the power switch, then power on it again.
•
Push any key (If you do not pick up the soldering iron in
two minutes after pushing any key, the station will go
into suspend status again).
•
Pick up the soldering iron.
