109893
STYLE 7675 SLO-CLOZ™
FOR USE ON NON-LOCKING VALVES WITH SZ OR R-1 HANDLES
INSTALLATION AND ADJUSTMENT INSTRUCTIONS
This unit is designed to be installed on 3” and 3
1/2
” Akron Swing-Out™ Valves with either an SZ Twist Locking Handle (Series 7600 or
8600 Valves) or an R-1 Remote Handle (Series 7600).
It is not intended for installation on Akron Style 7800 Series Valves with Tork-Lok®, 8800 Series self-locking Valves or any non
Akron Valve.
This unit is also not intended for Akron Valves with a Rack and Sector Actuator.
Note: the Slo-Cloz mechanism will add approximately 2” in height to the valve. Be sure there is enough clearance to allow the unit to
be installed.
Identify the type of Valve Handle before beginning installation.
SZ Twist Handle: Slo-Cloz (p/n 7675-0001)
Note: For this unit to fit, the SZ Handle Hub must have 2 holes (
5/
32
”), one on either side of the bolt.
R-1 Remote Handle: Slo-Cloz (p/n 7675-0002)
Note: For this unit to work, the Stops built into the Body must be machined with a hole in the side of the
machined surface.
INSTALLATION - Valves with the SZ Handle
1. Place the Valve in the
1/
2
open position. Note the position of the Handle.
2. Remove and discard the Bolt holding the Handle on the Valve.
3. Remove the Handle assembly.
4. Place the Collar (#1) on the Valve and align it so the notch in the boss of the Collar is opposite the Handle and aligns with the
Center on the Handle.
5. Replace the Handle assembly.
Slo-Cloz Collar with
Bolts
Slo-Cloz Stud for SZ
Handle
1
2
5
4
3
