akpo WK-4 ANDROS ECO, Instruction Manual

Page: 20 / 22

page
20
1. Disconnect the kitchen hood from the power supply,
2. Open the glass element (Fig. 5)
3. Remove the grease filter (Fig. 7)
4. Remove the grease filter located inside the kitchen hood on both sides of the fan
housing (Fig. 7) or one filter on the fan housing front side Fig. 8 by rotating it
counterclockwise,
5. Performing the activities in the reverse order compared to point 4, place a new filter
on the fan housing and rotate it to protect the filter against sliding off.
IMPORTANT:
Always remember to replace two filters at the same time (applicable to
kitchen hoods equipped with fan operating with two active charcoal filters).
5.3 LIGHTING
The lighting system consists of two LEDs (Fig. 9) or a LED line fixture (Fig. 10) -
depending on the option.
Fig. 9 Fig. 10
Replacing the light bulb (Fig. 9)
1. Disconnect the kitchen hood from the power supply,
2.
Press the light bulb and rotate it about 45º counterclockwise,
3. Remove the used light bulb,
4. Insert a new light bulb in reverse order,
5. Connect the kitchen hood to the power supply.
Important:
If the LINE LED FIXTURE (Fig. 10) is damaged (burnt-out), it should
be replaced with an original line led fixture available at the
manufacturer or special repair facility, and the replacement should be
performed by a trained serviceman.
5.4 CLEANING
Before cleaning, disconnect the power cord from the socket. Use a damp cloth with a non-
corrosive cleaning agent to clean the exterior of the lacquered kitchen hood. You can use