LED Code Summary
LED
combination
LED
comb. no.
Description
Description
Action
10
Undervoltage
Battery voltage is
too low / completely
empty
If battery is not charging after 5 minutes and charger is indicating defective
battery please contact your IDEX Fire & Safety technical service.
16
Load Overcurrent
1 (>52A for 5s)
Current consumption
between battery and
tool is temporarely
too high
Wait until the error code is gone (min. 30s). Check the battery function using
another tool.
If the error persists with second tool contact your dealer otherwise check the
first tool to exclude its defect.
17
Load overcurrent 2
(>156A for 160ms)
Current consumption
between battery and
tool is temporarely
too high
Check battery on another tool and after minimum 30 sec the error should be
gone.
If the error persists with the second tool contact your dealer otherwise send in
the first tool for a technical revision.
18
Charge
overcurrent
Charging current
too high
Check battery on another charger and after minimum 30 sec the error should
be gone
If the error persists with the second charger contact your dealer otherwise
send in the first charger for a technical revision
19
Short circuit
Power consumption
too high – higher
than the overload
current
Be sure that „+ / -“contacts are not directly in contact via conducting materials.
Wait for at least 30 sec until the error should be gone, then check the battery
in another tool.
If the battery error code occurs in second tool please contact your dealer´s
technical service for assistance.
20
Temperature
not OK
Cell and FETs
temperature
is outisde the
recommend
temperature range
First adjust the Cells temperature by disconnecting or stop operating the
battery in order to let the battery cool down or warm up until it reaches the
maximum or minimum allowed temperature
Later if the battery is still blocked test the battery in another tool to test if the
the error persists.
If the battery error code occures in second tool please contact your dealer´s
technical service for assistance.
7
8
