Page 6 of 9
Figure 3-Connect the shielded cables to the volume control. Remember to remove the tab
Install the Volume Control
Once you’ve attached the shielded cables to the volume control, remove the locating tab
(see Figure 3) from the volume control using needle nose pliers. Install the volume
control in the front panel as shown in Figure 4-Locating the volume control. Turn it on its
side, as shown, with the center lug a bit below the center-line of the mounting hole.
It’s best if you have a nut driver to tighten the nut, although you can use pliers if you’re
careful not to let them slip and scratch the front panel. Once the volume control is
installed and tightened, turn the shaft fully counterclockwise (viewed from the front
panel).
Loosen the set screw on the knob and slip it over the volume control shaft. Set the
indicator to 7 o’clock and tighten the set screw.
Figure 4-Locating the volume control
