3.
Insert the switch in from the front of the chassis. It may be a snug fit.
Make sure that the | is at
the top of the opening
before you insert the rocker switch into the chassis. Push the rocker
switch in the rectangular opening; it will click into place.
4.
Dress the black-white twisted pair that goes from the switch to the power entrance connector
into the crease along the right side of the chassis.
5.
Dress the transformer primary leads as shown on the front cover of this manual.
6.
Lay the power supply assembly into the case, fin side down, centered along the back of the
chassis. The solder side of the circuit board should face the front of the chassis.
7.
Insert the blue and green transformer wires into the X1 and X2 terminals of the power supply
PCB, inserting them from the solder side and soldering them on the component side. Connect
blue to X1 and green to X2, but it doesn’t matter if they are reversed.
At this point, rejoin the main manual on page 41, “Testing the Power Supply”.
Figure 5 shows a recommended orientation of the installed transformer.
Figure 5-Antek transformer orientation