Page 5 of 52
Section 1: About This Manual
This manual gives the information you need to build Akitika LLC’s GT-102 Stereo
Power Amplifier.
Who Should Attempt this Project?
You can build this kit if you can:
1.
solder (using normal rosin core solder and a soldering iron).
2.
use simple hand tools like screwdrivers, wire cutters, and pliers.
3.
read and follow directions.
It helps if you:
1.
know a bit about electronics, or
2.
have a friend who knows a bit about electronics
3.
can get to YouTube to watch a few helpful videos about the assembly process
Tools You’ll Need
You’ll need the following tools:
1.
Phillips screwdriver (#1 and #2)
2.
pliers or nut drivers suitable for #6 hardware (5/16” nut driver or hex wrench).
Note that the 5/16” nut driver is also the correct size for the speaker binding post
nuts.
3.
needle nose pliers (helpful, but not strictly necessary)
4.
pencil type soldering iron of 25 to 50 Watts (no huge honking soldering guns or
blowtorches)
5.
wire cutters and strippers
6.
multi-meter (strongly recommended to check resistor values!)
7.
magnifying glass, if you’re over 42!
Project Overview
The project consists of the following steps:
1.
Build the Power Supply Regulator Board
2.
Build left and right channel amplifier circuit boards.
3.
Install and wire the circuit boards, switches, and connectors into the chassis.