akira VCR-S607, Service Manual

Page: 8 / 46

-
8
-
Model No.: VCR-S607
Version: 1.0
17 Observe the original lead dress, especially near the following areas: Antenna wiring, sharp edges,
and especially the AC and high voltage power supplies. Always inspect for pinched, out of place, or
frayed wiring. Do not change the spacing between components and the printed circuit board. Check
the AC power cord for damage. Make sure that leads and components do not touch thermally hot
parts.
18 Picture Tube Implosion Warning:
The picture tube in this receiver employs “integral implosion” protection. To ensure continued
implosion protection, make sure that the replacement picture tube is the same as the original.
19 Do not remove, install or handle the picture tube without first putting on shatterproof goggles
equipped with side shields. Never handle the picture tube by its neck. Some “in-line” picture tubes
are equipped with a permanently attached deflection yoke; do not try to remove such “permanently
attached” yokes from the picture tube.
20 Product Safety Notice:
Some electrical and mechanical parts have special safety-related characteristics which might not be
obvious from visual inspection. These safety features and the protection they give might be lost if the
replacement component differs from the original--even if the replacement is rated for higher voltage,
wattage, etc.
Components that are critical for safety are indicated in the circuit diagram by shading, ( or ).
Use replacement components that have the same ratings, especially for flame resistance and
dielectric strength specifications. A replacement part that does not have the same safety
characteristics as the original might create shock, fire or other hazards.
All manuals and user guides at all-guides.com