akira VCR-S207, Service Manual, Page: 8 / 40

-
8
-
Model No.: VCR-S207
Version: 1.0
17 Observe the original lead dress, especially near the following areas: Antenna wiring, sharp
edges, and especially the AC and high voltage power supplies. Always inspect for pinched,
out of place, or frayed wiring. Do not change the spacing between components and the
printed circuit board. Check the AC power cord for damage. Make sure that leads and
components do not touch thermally hot parts.
18 Picture Tube Implosion Warning:
The picture tube in this receiver employs “integral implosion” protection. To ensure
continued implosion protection, make sure that the replacement picture tube is the same as
the original.
19 Do not remove, install or handle the picture tube without first putting on shatterproof
goggles equipped with side shields. Never handle the picture tube by its neck. Some
“in-line” picture tubes are equipped with a permanently attached deflection yoke; do not try
to remove such “permanently attached” yokes from the picture tube.
20 Product Safety Notice:
Some electrical and mechanical parts have special safety-related characteristics which
might not be obvious from visual inspection. These safety features and the protection they
give might be lost if the replacement component differs from the original--even if the
replacement is rated for higher voltage, wattage, etc.
Components that are critical for safety are indicated in the circuit diagram by shading,
( or ).
Use replacement components that have the same ratings, especially for flame resistance
and dielectric strength specifications. A replacement part that does not have the same
safety characteristics as the original might create shock, fire or other hazards.