akira LCT-37EL0SST, Service Manual

Page: 53 / 54

53
Model No.: LCT-37ELOSST.doc
Version: 1.0
WALL-MOUNTING BRACKET INSTALLATION GUIDE
READ CAREFULLY BEFORE INSTALLATION!
THE INSTALLATION GUIDE SHOULD BE RETAINED FOR FUTURE REFERENCE.
Caution:
1. Do NOT attempt to install the TV by yourself to avoid mistakes or hazard. Refer all
installation to qualified servicing personnel.
2. DO NOT install the TV on a wall aslope or a wall that makes the TV screen sloping over
25º off plumb line. Otherwise, it may cause tumble or injury.
3. One must follow the instructions in this guide to correctly install the TV.
4. It requires more than one person to install the TV.
5. Before installation, examine whether the wall conforms to the specifications and whether
the supplied parts can be fixed on it. The wall for mounting should sustain the weight of TV
and speakers e.g. cement wall or brick wall. DO NOT attempt to install an area with
standard building rigidity, which sustains the weight of the TV and speakers. If the rigidity
of the wall can not be measured, every mounting hole should sustain a frontal force over
75N
, and a shearing force of over
150N
.
6. Use the specified electric drill and drill bit for drilling. The drilling holes should conform to
the specifications.
7. To avoid fire and shock, do NOT place radiator, heater or humidifier below the installed TV.
8. The TV should be kept away from moisture, sensors and power line. The TV should be
kept away from impact and vibration.
9. Ensure that the power supply be disconnected before installation for fear of fire and shock.
Wall-mounting Installation Steps:
1. Take out the bracket form the package and check if there are serious defects (e.g. infirm
juncture).
2. Adjust the bracket to the desired angle. Use bolt 7 to adjust the angle by meeting holes of
column beam2 and holes of lever 4.
3. Drill locating holes in the specified dimension in a vertical wall of concrete or brick. The
hole size should be 11mm. The hole depth should accommodate the expanding tube of the
bolt.
4. Fix the bolts into the drilled holes in step3, and then cover each bolt with a metal washer.
Meet the four mounting holes in the bracket with the four bolts in the wall, cover each bolt
with a metal washer, and then fasten with a screw nut. Check its rigidity by pulling the
bracket.
5. Fix the fixture disk to the back cover of the TV using six M4x20 bolts.
6. Wall-mount the TV by putting the six-fixture disk into the six mounting
holes A.