akira 21SHS3 Series, Service Manual

Page: 12 / 61

12
Model No: 21SHS3-CE.doc
Version 1.0
B Two-None (no picture, no sound)
The failure shows that the set does not display the picture but it has noise wave or blue background or OSD on the screen. This means that the circuits of power supply, horizontal scanning, vertical scanning
and video amplification are normal and they are not considered in the repairing. The failures are mainly in the small signal processing circuits.
Before checking these circuits, a kind of practical test method is introduced. It is called “Signal-input way ”. The detail is described as follow: We can use the resistance function of an analog multimeter,
connect the red pole (negative in ohm scope) on the circuit board ground, then touch softly the test point with another pole (black pole) in ohm scope meanwhile observe the reactivity on the output device.
Note : In the TV test, we mainly observe the noise wave on the CRT and listen to the noise voice liking as “Ka…..Ka” from the loudspeakers.
1. No picture
YES
No variation
Out of the “ 0-33V ” range
0V
NO
No picture
Check the “ +5V ” voltage on A101
Check RF signal input and adaptor
Check N703, A101
Check R301,R302,
N301,A101
Check the “ VT ” voltage when auto searching
Check R707, C707, A101
The voltage between VL and BH vary from 0V to
5V or not when auto searching
Check R703,N703,C703A
The voltage on the C703
Check the voltage on the C705
Check ,V701,N301, R701, R701A
,R704,R705,C701,C705,C706
Check if A101 has input signal
0V
YES
In the “ 0-33V ” range
5V
＜ 33V
＝
33V
0-33V