3
Swing Spout
5
6
INSTALLATION PROCEDURES
Remove any debris from valve outlets.
Turning off the water supply valves. This is usually
found near the water meter. If you are replacing
an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
Install without Deck Plate. Make sure the O-RING
is placed onto the bottom of Base Ring. Install
faucet through hole in sink. From underside sink,
attach mounting assembly Position
faucet on sink properly and tighten Mounting Nut.
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
Connect hot and cold water supply lines to the
Hot
Cold
Water
Supply Valves.
2
1
2A
3
4
Close
Open
After installation is complete, remove aerator and rotate
handle to the closed position. Turn on the water supply
valves, and check all connections for a leak. Turn on
your faucet and allow both hot and cold water to run at
least one minute each. Replace Aerator.
Faucet Start Up
2B
Install with deck plate. Place a bead of plumber's putty
between faucet and sink. Place deck plate over the three
holes of sink.
Make sure the washer is placed onto the bottom of base ring.
Install faucet through deck plate. From underside sink, put
plastic washer and mounting nut. Position faucet on sink
properly and tighten mounting nut.
Open the valve, then turn the handle according to the
sign of C and H on the handle to regulate the temperature
of the water. (C=Cold,H=Hot)
