12162021JA
www.akiascreens.com
U-00206
5
Center Support Bar
Step 8:
Insert the
Center Support Bar
(o)
into the upper top groove on the
back of the frame with the bottom end
near the approximate center point of
the frame and rotate it in at an angle so
that both ends of the bar are in
alignment with the groove.
Step 9:
Hook one end of the spring and secure inside the groove of the frame, use the
spring hook (i)
to attach the
spring to the hole located on the screen material’s outer edge in the following order.
Begin by first attaching the center points on both vertical (left/right) sides,
steps 1-2
. Then the center points on both
horizontal (top/bottom) sides,
steps 3-4
. Once all center points have been secured, make sure the screen material is
still within the marked areas before proceeding to attach the next springs.
Continue attaching the rest of the springs to the material in the following order in
steps 5-12
.
To avoid ripples forming in the material it is imperative that all of the corners are properly wrapped around the
edges as illustrated in the check mark diagrams.
o.
h.
i.
5
6
7
8
9
11
10
12
1
2
3
4
