Akai QX-4200 Operator'S Manual Download Page 3

20. DAMAGES REQUIRING SERVICE 

- Unplug this product from the wall outlet and refer servicing to qualified service personnel

      under the following conditions.

 a) When the power-supply cord or plug is damaged.
 b) If liquid has been spilled, or objects have fallen into the product.
 c) If the product has been exposed to rain or water.
 d) If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered
    by the operating instructions as an improver adjustment of other controls may result in damage and will often require
    extensive work by a qualified technician to restore the product to its normal operation.
 f) When the product exhibits a distinct change in performance - this indicates a need for service.

21. REPLACEMENT PARTS

 - When replacement parts are required, be sure the service technician has used replacement parts

       specified by the manufacturer or have the same characteristics as the original part, Unauthorized substitutions may result in fire,
     electric shock or other hazards.

22. SAFETY CHECK

 - Upon completion of any service or repair to this product, ask the service technician to perform safety checks

     to determine that the product is in proper operating condition.

23. HEAT

 - The product should be situated away from heat sources such as radiators, heat registers, stoves or other products

     (including amplifiers) that produce heat.

15. LIGHTENING

 - For added protection for this product during a lightening storm, or when it is left unattended and unused for

long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will present damage to the
product due to lightening and power-line surges.

16. POWER LINES 

- An outside antenna system should not be located in the vicinity of overhead power lines or other electric light

or power circuits, or where it can fall into such power lines or other electric light or power circuits, or where it can fall into such
power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power
lines or circuits as contact with them might be fatal.

17. OVERLOADING

 - Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk

of fire or electric shock.

18. OBJECT AND LIQUID ENTRY

 - Never push objects of any kind into this product through openings as they may touch

dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the
product.

19. SERVICING

 - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous

voltage or other hazards. Refer all servicing to qualified service personnel.

-GB- 3 -

      PREPARATION FOR USE

CD-R / CD-RW  play capability of this unit may vary depend on quality of media, CD burner and application software.

Unpacking and Setup

* Carefully remove the unit from the display carton and remove all packing material from the unit itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit. Do not remove any labels located on
  either the back or button cabinet of the unit.
*  Open the CD compartment door. There is a white card in the CD   compartment which is Intended  to prevent the CD  pickup from
   moving during shipment of the product. Remove this card from the CD compartment before use.

Power Sources

This audio system is designed to operate on  230V AC 50Hz house current .  Attempting to operate this unit from any other power source
may cause damage to unit, which is not covered by your warranty.

AC Operation

Unwind the AC cord and extend it to its full length,  Insert the  AC  plug into  any convenient 230V AC 50Hz household outlet .
*  Hold the plug to disconnect it from the mains outlet. Do not pull the power cord.
*  When the plug of the unit is connected to the mains outlet, the unit will be still connected to AC even of the power is turned off.
*  Disconnect the plug as soon as liquid or objects enter the unit. The unit cannot be used until being checked by experts.

-GB- 4 -

Summary of Contents for QX-4200









Reviews: