Akai ECO E2, Quick User Manual

Page: 3 / 31

3
Basic Information
1.
Safety Notice
When you contact with telecom department or commission agents, they need to know your
phone IMEI number (printed on the label on the back of the phone and can be found after
taking down the battery). Please copy the number and keep it safe for future use.
2.
Install and Unload SIM Card
Before using the phone, you must insert valid SIM (Subscriber Identity Module) card in the
phone. SIM card provided by network supplier.
Power off the phone, remove the rear cover, battery or other external power
supply.
Make the end of SIM card without cutting angle inside and aim at the card slot of the phone
and metal surface of SIM card face downward, then insert SIM card to the card slot of the
phone, the other SIM card is also inserted in this way.
When taking out SIM card, directly pull it outward and then can take out SIM
card.
3.
Install and Unload MICRO SD Card
Aim at the T card slot and push the T card gently, and the card will be inserted
correctly.
Prompt:
If the memory card is failed, please check whether it is correctly placed and good contact
of metal point.
4.
Install and Unload Battery
Take off the rear cover of the mobile. Make one end of battery with metal surface aim at the
battery connector. Then gently press the battery downward using the finger, and then press the
other end to install the battery.
Prompt:
Please operate correctly to avoid damaging the battery connector.
5.
Charging
Insert the charger on the charging interface at the top of the phone. After inserting the
charging plug, battery strength icon stripe at the top right corner of the screen is scrolling,
which means that the charging is processing; when the stripe is full of the whole icon and stop
scrolling, which means that the battery charging is completed; when the charging is completed,
please pull out the plug. When electric quantity is not enough, warning message will be sent;
and electric quantity shows
empty. When electric quantity is too low, the phone will power off automatically. Please don’t