7
8
CONNECTING TO AC POWER
EFFECTIVE DISTANCE OF REMOTE TRANSMITTER
POWERING ON/OFF THE UNIT
.
AC Adapter
Insert the USB plug of the USB Connection Cable to the socket of the AC power adapter and the mini
USB Jack to the DC IN Jack (mini USB Port) on the unit. Insert the AC power adaptor to wall outlet
having AC 120V, 60 Hz. This power unit is intended to be correctly orientated in a vertical or floor mount
position.
Note: When the unit is not operated by the AC power or unused for long period of time, please remove
the power adapter from the wall outlet and unplug from the main unit.
1. After connecting the AC power, the STATUS indicator would light up in RED to indicate the unit is in
standby mode.
2. Press and hold the STANDBY/SOURCE button for 3 seconds to turn on the unit.
3. After using the unit, press and hold the STANDBY/SOURCE button for 3 seconds to switch the unit
to standby mode.
BATTERIES INSTALLTION (REMOTE CONTROL)
To replace the button cell:
1. Push the tab and then slide out the battery tray as the figure
shown on the right.
2. Clean the battery contacts and also those of the device prior
to battery installation.
3. Replace the old button cell by a new CR 2025 button cell as
the polarity markings on the remote control.
4. Close the battery tray.
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Reversed batteries may cause damage to the device.
3. Do not mix different type of batteries together (e.g. Alkaline and Carbon Zinc) or old batteries with
fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or
injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged, they can overheat and rupture
(Follow battery manufacturer’s directions).
6. Rechargeable batteries are to be removed from the product before being charged.
7. Rechargeable batteries are only to be charged under adult supervision.
8. Exhausted batteries are to be removed from the product.
9. The supply terminals are not to be short-circuited.
10. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
BATTERY WARNING
NOTES:
• When there is an obstacle between the unit and the transmitter, the transmitter may not be operated.
• When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the
REMOTE SENSOR of the unit, the remote operation may be unstable.
Approx. 16 feet
PUSH
OPEN
CR2025
PUSH
OPEN
Lithium Cell
CR2025
3V
S
C U
L
Lithium Cell
CR2025
3V
SC UL
USB Connection
Cable
Summary of Contents for CE7001-BT
Page 2: ......
