POWER SOURCES
PLAYER MAINTENANCE
Cleaning the Cabinet
IMPORTANT: Disconnect from Main Supply Before
cleaning.wipe with a soft cloth. If the cabinet is very
dirty, dampen the cloth with a weak solution of neutral
detergent and water, and then wipe clean.
Cleaning the Lens
A dirty lens may cause the sound to skip and, If the
lens is very dirty, the CD may not work. Open the
disc cover and clean the lens as follow:
Dry Dust Particles
Using a camera lens brush/blower, blow on the
lens couple times, then wipe it lightly with
the brush to remove dust. Then, blow on the lens
once more.
Finger prints
If the lens cannot be cleaned by using a brush/
blower use a dry cotton swab.
GB-2
DISC CLEANING, POWER FAILURE
Cleaning the Disc
1.To handle a disc use only one of the two
manners.
Note: Do not touch the rainbow colored side.
2.To wipe a disc, use only a soft cloth. Do not
use benzene or thinner which will damage the
disc, the disc should always be wiped in a
straight line from the centre to the edge. It
should never be wiped in a circular motion.
3. Never place the disc on other equipment or
near any heat source. Avoid positions where
the disc would be subjected to direct sunlight
for long periods.
Power failure
When AC power is interrupted, both time
and alarm settings will be lost (unless 2 x
AAA battery (not supplied) is installed)
after power is restored. The digital display
will blink to show power was interrupted.
You must reset time and alarm times.
Battery back up
To keep alarm and time of day settings in
memory during a brief power failure or
accidental removal of AC cord from main
socket, install 2 x AAA battery (not
supplied) into the battery compartment
on the underside of the unit.
1 .
Electronic products should never be
subjected to extreme temperatures nor
high humidity to ensure good performance
and a long life-time.the clock radio should
not be placed in bathing areas, or around
stoves and radiators, etc.always leave
sufficient space around the unit for
ventilation.
2. If necessary, only clean the cabinet of
the unit with a soft dampened piece of
cloth, (be sure the AC power cord is
unplugged from the outlet).never use a
polish or a strong detergent for cleaning
since this can damage the finish of the
cabinet.
3. If the electric cable is damaged, it must
be replaced by the manufacturer, or by
the qualification persons, in order to
avoid a danger
3
Corrosion, oxidation, battery-leakage
and any other gradually acidic defect of
this nature will invalidate the guarantee.
Maintenace and care
