12V PSU for Hub/Hub Plus/ReX User
Manual
Updated May 4, 2020
12V PSU for Hub/Hub Plus/ReX is a power supply unit, connecting the Hub/Hub
Plus control panels as well as the ReX radio signal extender to 12 volt DC
sources. This is an electronic board, replacing the standard 110/230 V power
supply unit in the body of the device.
Installing
12V PSU for Hub/Hub Plus/ReX should be installed by a quali ed electrician only.
Before installing the power supply, make sure that the device is disconnected
from the mains.
When installing the 12V PSU for Hub/Hub Plus/ReX, follow the general electrical
safety rules, as well as the requirements of electrical safety regulatory acts.
Never disassemble the device while it is under voltage!
Installation process:
1. Remove the screws and take off the device from the SmartBracket
mounting panel, shifting it down with force.
