V2Digital Mini-Converter v2.2
www.aja.com
8
Chapter 2: Operation
Default Operational Settings
The V2Digital converter ships from the factory with the following configuration:
• Local (DIP switch) control
• Component video input
• YPbPr format
• Pedestal Off
If these settings apply to your requirements, you can simply connect the video input and
output signal cables and power up the V2 Digital unit.
For other applications, you can configure the unit using its DIP switch settings, or by
using MiniConfig and a PC or Mac via USB. When configured for “component” V2DIGITAL
will auto detect between various component standards.
DIP Switch Settings
Four DIP switches are located on the bottom of the unit. The label on the bottom of the
unit identifies the functions of the switch positions. The default shipping position for
these switches is Off (down). By default, DIP switch configuration is enabled, and
MiniConfig control is disabled.
Use a pen-point or paper clip to change DIP switch positions.
Figure 2. DIP Switches.
NOTE:
BetaJ is only accessible via MiniConfig.
Table 1. DIP Switch Setting Descriptions
SWITCH
FUNCTION
OFF (Down)
ON (Up)
1
Control
Selects Local (DIP), and blocks
MiniConfig control
Selects Remote
(MiniConfig), and disables
DIP switches 2-4.
2
Input
Selects Component
Selects Composite
3
Color Space
Selects YPbPr in Component
mode, S-Video in Composite
mode
Selects RGB in Component
mode, Composite in
Composite mode
4
Pedestal
Selects Off
Selects On
ON
OFF
DIP Switches
