FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1 70 www.aja.com
7 Mix Down Reset
This parameter resets all of the mix down levels (five or seven input, two output)
for the selected mixer to the factory defaults. Turn the ADJIUST knob to select
the mixer. Two mixers are available in Four Channel Mode, and only one mixer is
available in Single Channel mode. After selecting a mixer, press ADJ. An “Are you
sure” prompt is displayed. Pressing ADJUST again resets that mixer...
Mix Down 1
Mix Down 2 (4Ch only)
Resets the Mix Down 1 mixer levels to default settings.
Resets the Mix Down 2 mixer levels to default settings.
8 Global Audio Output
This parameter allows routing the same source or set of sources to all the FS-HDR
audio outputs. The rules used for Audio Out apply if the number of outputs do
not match the number of inputs.
Off (default)
No Global output configuration is imposed. When Off all other AUDIO
OUTPUT menus are enabled and displayed.
SDI1
SDI2-8 (4Ch only)
AES.EBU
MADI BNC
MADI Fiber
The selected source channels are routed to all the FS-HDR audio
output channels.
Sig Gen 1KHz
Sig Gen 400Hz
Mute
The selected tone or mute is routed to every FS-HDR audio output
channel.
Mix Down 1 L:R
Mix Down 2 L:R (4Ch
only)
The stereo output of Mix Down module is routed to all the FS-HDR
audio output channels. The Left mixer channel goes to FS-HDR
output channel 1 and the Right mixer channel goes to output
channel 2. If the output has more than two channels (i.e. embedded
SDI), mute (silence) is routed to the higher numbered output
channels.
NOTE: No Global Map source is available.
9 Reset Mapped Output
This parameter resets the selected output map to the factory default values
Choose a Map (default)
Prompt for selecting an Output to map.
SDI1
SDI2-8 (4Ch only)
AES.EBU
MADI BNC
MADI Fiber
After selecting an output, press
ADJUST
to reset that output to the
factory default mapping (i.e. SDI1 to SDI1, SDI2 to SDI2, etc.).
All
Sets all outputs to their factory default mappings.
PRESET Menu Group
The PRESET Menu Group provides the means of saving, editing the names of, and
loading FS-HDR presets. A preset is a set of all System, Video, Audio, and most
Config parameters as they were set at the time the preset was stored.
Caution! When you recall a Preset Configuration, the recalled preset immediately
replaces the system’s existing configuration. All previous settings are lost unless
you have previously stored them in another preset configuration or an exported
file
