Assembly Instructions
Section 1 — Wings
1)
U lizing a hot knife, cut carefully and remove the covering exposing the servo pocket located on the un-
derside of each wing.
2) Carefully locate and cut the aileron control horn slot on the underside of the aileron.
3) Using low tack masking tape, tape around the edges of the aileron control horn slot leaving slot exposed.
4) Remove the aileron control horn from bag and slightly roughen the surface the epoxy will go on to assure
good adhesion.
5) Using the 15 minute epoxy, apply epoxy to the control horn and then insert in slot paying close a)en on
to orienta on.
6) Clean any excess epoxy using a piece of paper towel soaked with the alcohol and remove tape. Let the
epoxy cure before proceeding.
7) A)ach 12 inch servo extensions onto the servo leads and using the string inside the wing tape the exten-
sion to the string and pull the extension through the wing.
8) Install servos into wing u lizing the hardware that came with the servos.
9) Double check that the pre-installed aileron hinges are secure with a slight tug on the control surface.
It is highly recommended that you u lize a method to prevent the servo from disconnec ng
from the extension. One recommenda on is to place heat shrink tubing over the junc on
between the servo and extension and then shrink it to keep the connec on secure.
Tip
: Drill pilot holes for the screws and then install the screws. Remove the screws
and then u lizing thin CA, place the CA in the and around the screw holes leHng the
CA dry. This will harden the area and provide a more secure mount
Summary of Contents for Laser 230z
Page 1: ...Assembly Instructions ...
