© Aixro GmbH / Woelfle Engineering GmbH
9/23
4.6.2.
Onboard Starter
If your engine is equipped with an onboard starter, you need a battery with a compatible bat-
tery tray and cables. Use a maintenance-free (MF type) lead-acid battery (no gel) with min.
7,2Ah and temporary 100A. Though the ignition has an integrated charging function, make
sure the battery is always charged sufficiently.
1.
Connect the ignition wires as shown on the diagramme below.
2.
Mount the battery in an appropriate position.
3.
Run the cables along the chassis, securing them so they cannot wear or hit the ground.
Make sure the cables cannot make any electrical contact with the chassis.
4.
Attach the CDI box. Typically the best position is on the back of the seat. The CDI box
should not be too close to the engine or the exhaust.
5.
Mount the stop button / kill switch, so it is easily visible for the driver. The steering
wheel is the best location. If it should not be possible to attach the switch to the steer-
ing wheel, you should drill a hole (Ø 15mm) in the Nassau Panel (within easy reach of
the driver) and attach the switch there.
Use sufficiently big cables for the conductive circuit between battery, relay and starter motor
(10mm² / AWG8). 1.5mm² / AWG16 cables are sufficient for the control circuits.
! A shortcut between the battery terminals can destroy the battery or cause explosion of
the battery.
! To avoid short circuits during transportation you should always disconnect the posi-
tive terminal (+) from the battery when you stop your kart.
Summary of Contents for XR50
Page 1: ...OPERATION MANUAL...
