Aiwa XP-ZV1, Operating Instructions Manual

Page: 24 / 30

24
English
Troubleshooting guide
Should any problem persist after you have
checked these symptoms, consult your nearest
dealer.
Playback does not start.
• Connect the AC power adaptor firmly.
• Insert the batteries with the correct polarity.
• Charge the rechargeable batteries.
• Check that the disc is inserted with the label
side up.
• Clean the disc or the lens.
• Close the disc compartment lid.
• Release the HOLD switch.
• Press
ca /ENTER to cancel pause.
• There is a moisture condensation. Leave the
unit for a few hours and then try to play
again.
• While “POWER OFF” is shown in the
display, playback does not start even if you
press
ca /ENTER. Wait until “POWER
OFF” goes off, and press ca /ENTER to
start playback.
No sound
• Connect the headphones to the remote
control firmly, and connect the remote
control to the
\ jack on the CD player.
• Turn up the volume gradually.
Sound skips. Sound is intermittent.
• Clean the disc or lens.
• Check whether the CD player is subjected to
strong vibrations.
• Use the new batteries, or charge the
rechargeable batteries.
Charging cannot be done.
• Connect the AC power adaptor to the
charging stand correctly.
• Place the CD player on the charging stand
correctly, aligning the terminals of the CD
player and the charging stand.
• Check that the dry batteries or the
rechargeable batteries are installed with the
correct polarity.
• Connect the AC power adaptor to the EXT
BATT/DC IN 4.5V jack, and press s /
CHARGE to start charging without using the
charging stand.