LogiScan-17xx Operating Manual ___________________________________________
Edition 22.11.2018 _____________________________________________________ aitronic
3
instructions contain information such as the state of charge to check and how
the batteries must be recharged.
Observe and register the term, which can be reached with a new, fully charged
battery with your device. Use the term of a new battery as a basis to compare
the runtimes with older batteries. The duration of the batteries varies depending
on the configuration of the device and applications that are running.
Batteries that have almost reached the end of their estimated life is to carefully
monitor.
Replace the battery with a new one of the following conditions applies:
The battery life is less than about 80% of the initial term.
The battery charge time increases significantly.
If a battery is stored for long periods of time or otherwise not used, please see
the instructions for the storage of batteries in this document. If you have not
followed the instructions and the battery has no charge, you look at it as
damaged and replace it with a new one.
Observe the loading instructions in the user manual of the product and / or the
detailed online help to recharge your batteries.
Charging or discharging the battery to approximately 50% of capacity before
storage.
Charge the battery to approximately 50% of capacity at least once every 6
months.
Remove the battery and store these separately from your device.
Store the battery at a temperature between 5 °C and 20 °C (41 °F and 68 °F).
Charging the Battery
Direct Charging:
Connect AC adapter with charging cable or AC adapter with
USB cable to USB jack of the Snap-On.
Please notice
: If the device should be charged via the AC
adapter, the USB cable has to be disconnected, otherwise the
charging will be done via the USB cable.
Cradle Charging:
Connect AC adapter to the cradle and plug LogiScan-1700
into the cradle.