Installation & Operation
Radiant Infrared Heater
WARNINGS
This electric appliance produces infrared heat and failure to follow
READ AND SAVE THESE INSTRUCTIONS!
WARNING
FIRE OR EXPLOSION HAZARD
•
Failure to follow safety warnings exactly could
result in serious injury or property damage.
•
liquids, including aerosol cans, in the vicinity of this
appliance while it is operating.
•
materials on, or allow them to come in contact
with the unit: rags, fabrics ,spray or aerosol cans,
cleaning compounds, plastics or plastic containers,
•
Do not install the heater close to furniture, curtains
•
Do not cover or otherwise obstruct the heater.
WARNING
PERSONAL INJURY HAZARD
•
Do not touch the heater during operation. Burn or
scald injury could result. The casing and front cover
are extremely hot during operation.
•
Keep children away from the heater. Never leave
an unsupervised child near the heater.
•
Because of injury risk, the heater should be
operated only by individuals knowledgeable about
the operation and familiar with the warnings and
cautions listed in this manual.
•
Because of injury risk, this heater is not intended
for use by persons with reduced physical, sensory
or mental capabilities.
WARNING
PERSONAL INJURY HAZARD–SERVICE
•
To avoid property damage, personal injury or death
due to electrical shock, do not service the unit
and allowing adequate time for the unit to cool down
completely.
2
•
service technician.
•
Do not use the heater if the power cord is damaged.
Contact an authorized service technician or
•
Do not let the cord hang over the edge of a table or
counter, or come into contact with hot surfaces.
WARNING
INSTALLATION & USE
To avoid property damage, personal injury or death
due to electrical shock, follow all instructions in this
Installation and Operation manual.
•
All local, regional and national electric codes and
local construction codes must be observed in the
installation of the heater.
•
electrician or service technician.
•
Be sure the voltage listed on the heater’s
nameplate is the same as the voltage at the
installation site.
•
Do not use the heater if the power cord is
damaged. Contact an authorized servicer or
electrician to replace the cord prior to use.
•
Remove the plug from the power outlet and wait
CAUTION
•
Never use with an extension cord or multi-socket.
•
Never leave the heater unattended while it is
operating.
•
Do not install the heater immediately below a wall
socket outlet.
•
Do not use a timer or other device that
automatically turns on the unit.
•
Do not use the heater with an external voltage
regulator such as a dimmer or speed controller.
AITONS EQUIPMENT
