Aitchison SEEDMATIC PROFESSIONAL 8140, Manual, Page: 30 / 61

30 | P a g e
Advanced Settings:
The advanced settings menu is used for system
configuration. This is where the wheel
circumference can be set, and the dedicated-on
screen keyboard can be enabled/disabled.
At the top of the advanced settings menu, a tile
cluster shows the: Top Speed, Total Seed Area
and Total Fert Area for the lifetime of the system.
This is not resettable and will track over the
lifetime of the interface.
This menu is found using the settings menu at the
top right of the home screen.
See:
Settings , Keyboard .
Empty Hoppers:
This feature allows the operator to run the motors without holding down the prime
buttons. It is enabled and disabled by selecting the “Empty Hoppers” button in the top right
“Settings” menu of the home page. Once enabled, each motor can be start
ed or paused by
pressing and releasing the corresponding prime button on the machine.
See:
Settings .
Refresh:
This restarts the user interface and has no effect on the operation of the Machine.
It is found in the top right “Settings” menu on the home page.
See:
Settings .
Keyboard:
An on-screen keyboard is shown when an input field is selected. The keyboards layout will
be customised for the input field (i.e. “qwerty” for text and “numpad for” numbers). This
keyboard can be disabled/enabled in the “Advanced” settings menu.
See:
Advanced Settings .
Quick Start Guide:
This section provides a brief description of how to operate the E-Drive Head Unit for a
new Job instance.
1. Check connections and mounting .
2. Switch on: using the green switch on the right side of the monitor. The boot
sequence will take approximately 1.5 minutes.
3. Start Interface : Hit the “Start” button on the bottom of the screen.
4. Create a New Job : Open the Job Manager and start a new job by clicking “Ne w
Job”. Wait for the interface to load. Important: Make sure the previous job was
saved using the “Save Job” button as unsaved information will be lost when the
new job is created.
5. Set Job Info : Open the Job Info Dropdown menu and fill in the relevant
information. If applicable, copy information from a previous job (See Job Log ).
Once finished, hit the “Save Changes” button to commit the changes. Close the
2.60
6