AIS OF19T100-A1-PCT, User Manual, Page: 12 / 21

American Industrial Systems - OF19T100-A1-PCT User Guide Page 12
Connecting the Display
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC adapter to the power connector on the monitor and the other end
into an electrical outlet.
3. Connect the D-SUB cable from the display’s VGA input connector to the D-SUB
connector of your host computer and tighten the screws.
4. Connect the RS-232 or USB cable from the RS-232 or USB port of your display to
the RS-232 port or USB port of your computer.
5. Configure the touch screen. Refer to the “Touch Screen Driver Installation” section
on page 19.
6. Once the touch screen is configured, the monitor is ready for use.
7. Connect the remote control cable to RJ-Type port
! Notice!
To ensure the LCD display works well with your computer, please configure the display
mode of your graphics card to make it less than or equal to 1280 x 1024 resolution and
make sure the timing of the display mode is compatible with the LCD display.
We have listed the compatible “Video Modes” of your LCD display in the appendix (on
page 19) for your reference.
Don't connect telephone or internet cable to RJ-Type port.
Adapter rating: 12Vdc 4A min., marked with LPS.