AIS DTR19T100-A1-PCT, User Manual

Page: 12 / 22

American Industrial Systems - DTR19T100-A1-PCT User Guide Page 12
Connecting the Display
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the AC power cord to the power connector on the monitor and the other end into
an electrical outlet.
3. Connect the D-SUB cable from the display's VGA input connector to the D-SUB connector of
your host computer and tighten the screws.
4. Connect the RS-232 or USB cable from the RS-232 or USB port of your display to the RS-232
port or USB port of your computer.
5. Configure the touch screen. Refer to the “Touch Screen Driver Installation” section on page
21.
6. Once the touch screen is configured, the monitor is ready for use.
!
Notice!
To ensure the LCD display works well with your computer, please configure the display mode of
your graphics card to make it less than or equal to 1280 x 1024 resolution and make sure the
timing of the display mode is compatible with the LCD display.
We have listed the compatible “Video Modes” of your LCD display in the appendix (on page 16)
for your reference.