5. AUTOMATIC MODE
5.1. Set-point temperature/operation mode time programming
The SuperMaster Controller allows you to set programmes on the Operation Mode in all the
systems in a homogeneous form, or the same on or off set-point temperature in all the zones of
all the systems simultaneously.
In each of these programmes, you can define the imposition mode to use. It can be Forced
Mode, Semi-Forced Mode or Free Mode according to the desired action.
Note:
Time schedules send the corresponding temperature range in each programme.
Time programming is independent for each control group. That allows different programming for
each control group
Z1…Z8
or a common programming for all groups
.
5.2. Selection automatique
The automatic operation makes to run previously made programmes (Fig.14). To use this
operation mode you need to have the SuperMaster controller time adjusted. Take into account
that the automatic operation mode can be activated regardless of whether or not there is a set
programme.
To activate the automatic operation mode, follow these steps:
1)
From the main screen, press on the icon
.
2)
Press on the automatic mode icon
.
3)
With the arrows, select the programme you want to activate: the set-point temperature
(
)
, the air-conditioning mode
(
)
or both of them at the same time
(
)
. Confirm
the automatic operation mode by pressing on
.
If the programme of
air- conditioning mode
is selected
(
)
, this icon
will appear.
If the
set-point temperature
(
)
is selected, this icon
will appear. The set-point
temperature and the time alternate every 5 seconds. In this case, the air conditioning mode can
be modified manually.
If the
mode and temperature
programmes
(
)
are selected at the same time, these icons
will appear. The set-point temperature and the time alternate every 5 seconds.
When the programmes are active, this icon
is shown on the main screen.
It is also shown if the last order sent is to start
or to finish
.
If you wish to switch off the programmes, it is enough to press on
on the main screen.
33
