36
ES
EN
FR
IT
PT
DE
AIRZONE LITE THERMOSTATS
To configure a Lite thermostat, follow these steps:
Wired Lite thermostat
-
Perform all the appropriate connections.
-
Connect the thermostat.
-
Press the LED
to confirm the association.
-
The number of the zone which associates with the thermostat is the lowest free available number.
-
If the association is correct, the LED
will flash green 5 times.
Wireless Lite thermostat
-
Open the wireless association channel of the main board, wait a few seconds so the control module, which will be
associated to the thermostat, opens its wireless association channel (the wireless opening LED must be solid red).
-
Insert the battery to supply the thermostat.
-
Press the LED
to begin the wireless search. The LED
will blink in green.
IMPORTANT:
The thermostat will display first the wireless control modules which are closer to it. Remember to
configure this thermostat near the wireless control module to associate for greater comfort.
-
The module which will be associated to the Lite thermostat will begin to make a “beep” for its identification. The LEDS
will show the signal level of this module:
o
Low signal range level (It is not recommended to perform the association).
o
Medium signal range level.
o
Good signal range level
o
Excellent signal range level.
-
Press the LED
to confirm the association, otherwise use
to select another module.
-
The number of the zone which associates with the thermostat is the lowest free available number.
-
If the association is correct, the LED
will flash green 5 times. If it flashes red twice, it means the thermostat is out of
range.
REMEMBER:
It is required to set the Main ID parameter of the Lite Controller for its proper functioning (see section
Advanced
settings – Blueface controller, Zone settings
).
Configure other functionalities of the LITE thermostat from the advanced configuration menu of a Blueface thermostat (see
section
) or Webserver Cloud (See Webserver Cloud installation manual).
IMPORTANT:
For changing the zone address, access the parameter Zone Address,
inside the advanced settings menu from a
Blueface thermostat
(see section
Lite thermostat reset
To reset to factory values of any Lite thermostat, turn up the microswitch 8 and place the thermostat on the base again. Press
on
, the LED will flash green twice when the reset process is completed.
To reassociate it, lower the microswitch 8, place the controller on its base and follow the steps displayed in the
Initial setup
section, on Lite Controllers.
Summary of Contents for ACUAZONE IBPRO32
