6
(SAFETY PAD & WEATHER COVER)
1
Layout mat on ground and attach
first clip into strap.
2
Attach strap with clip to the frame.(WARN-
ING) The trampoline is under heavy tension
& a great deal of effort may be required to
attach bands to frame. Be careful not to pinch
fingers or slip. Serious injury may occur!
3
Go directly across from where you
attached first strap, and attach the
second strap.
5
Use strap tools as shown for the fol-
lowing procedures. (3 people may be
needed).
DANGER: 3 adults are required to use strap tools in exact manner as illustrated in STEP 17. Straps will create high
levels of tension when assembled. Please use extreme caution not to pinch your fingers.
4
Attach two more sides directly
across from each other.
6
Follow sequence above. It’s impor-
tant to consistently attach the oppo-
site end of the previous straps to
even out tension.
7
Attach remaining straps until all
straps are attached.
8
Place foam over straps and frame
and insert quick-ties into foam at
holes. NOTE - The added strip of foam
should face down, against the top rail.
9
Foam must be securely attached
with quick-ties around entire perime-
ter.
11
That’s it! Your AIRZONE trampoline
is complete!
10
Pull the built-in weather cover over
the foam - just like a shower cap.
1
1
3
4
5
6
7
8
2
2
3
4
5
ASSEMBLY (Frame)
Refer to PARTS LIST for identification of parts.
1
Connect one top-rail with one rail-
connector.
2
Align the set-screws holes, insert small
set-screw & tighten.
3
Continue alternating top-rails with
rail-connectors.
5
Bring both sides of the circle firmly
together and secure with small set-
screw. A 3rd person may be required
to hold the other end down.
WARNING: 3 adults in good physical condition are required for the following assembly. Wear proper shoes and maintain balance to
prevent a fall. Failure to follow all instructions and warnings exactly may result in serious injury.
4
Secure each connection with a small
set screw.
6
Lay one U-shaped leg piece, one leg
extension, and one plugged leg exten-
sion on the ground.
SET SCREW HOLES
(facing up)
7
Connect both extensions to U-shaped
piece as shown. Align the set-screws
holes, insert large set-screws & tighten.
8
Turn U-leg so plugged holes are on right
side. Attach the U-leg assembly to the
top-rail as shown. The U-legs should
now connect 2 top rails & a rail connec-
9
Secure U-leg to top-rail with large
set-screws on each side.
11
Continue until all U-legs are in place.
10
Repeat procedure for each U-leg
and attach to top-rail with large set-
screws.
12
Make sure all set-screws are tight.
Frame is now complete.
PLUGGED HOLES ON
THIS SIDE ONLY
(facing down)
PLUGGED HOLES
ON THIS SIDE ONLY
(facing out)
(Plugged holes are for optional Safety Enclosure.)
Added strip of foam
