Airwell YDAS-025H-01M25, User & Installation Manual

Page: 19 / 64

1. This function help carry away the accumulated
dirt, bacteria, etc from the evaporator.
2. Press "CLEAN" button to enter this function in any
mode and it will show "CL" on the display of indoor unit.
3. This function will run about 30 minutes, and it will back
to the mode set before this function .You can press "ON/OFF"
or "Mode" to cancel this function during the process.
You will hear 2 beeps when it's finished or cancelled.
4. It's normal if there are some noise during this function
process, as plastic materials expand with heat and
contract with cold.
5.We suggest operate this function as the following ambient
condition to avoid certain safety protection features.
6. We suggest operate this function per 3 months.
OPERATING INSTRUCTIONS
Self-Clean function(Optional)
Indoor unit
Outdoor unit
Temp<30
5 <Temp<30
In each mode of COOLING/HEATING/FAN/DRY, adjust the
temperature(COOLING/HEATING), fan speed (COOLING/
HEATING/FAN)and swing as your favourite, then keep
pressing "I SET" button over 3 seconds until "AU" appears
on the display and the background of display change to
lighting, the remote controller will run and remember
these settings. You can reset it by repeat the above
operation.
In each mode of COOLING/HEATING/FAN/DRY, press "I SET"
button to active this function, the AC will run as your
favourite setting and you will see AU flashing on the
remote controller. Press it again or other buttons to
cancel this function.
I SET function(Optional)
16
SWING
MUTE HEALTH
SWING
I SET TURBO
IFEELC LEAN
SWING
MUTE HEALTH
SWING
I SET TURBO
IFEELC LEAN