OPERATIION
OPERATIION
7
8
AUTOMATIC
Simply set the FAN SPEED selector to the position . A microcomputer
automatically controls the fan speed when the AUTO mode is selected. When the air
conditioner starts operating, the difference between the room temperature and the set
temperature is detected by the microcomputer which then automatically switches the
fan speed to the most suitable level.
MANUAL
If you want to manually adjust speed just set the FAN SPEED selector as desired.
Each time the button is pressed, the fan speed is changed in sequence:
(
Low
)
(
High
)
(
Medium
)
(
Turbo
)
(
Auto
)
TURBO FUNCTION
In Cool or Heat Mode, if start the turbo function, the unit will run at super-high fan
speed to cool or heat quickly to approach the set temperature.
DEHUMIDIFYING (DRY)
1. Set the MODE selector switch to “DRY” .
2. Press the ON/OFF ( ) button and switch the air condioner ON.
3. Press the + or - buttons to set the desired temperature (Adjustable temperature
range is 16
℃
and 30
℃
(61-8
6
F)
)
.
THE
DISPLAY
SHOWS
THE
SELECTED
TEMPERATURE.
NOTE
Use DRY operation when you want to reduce the humidity in the room
.
Once the room temperature reaches the set level, the unit repeats the cycle of turning on
and off automatically
During DRY operation, the fan speed is automatically set to low or stops to prevent overcooling .
Dry operation is not possible if the indoor temperature is 15 °C or less.
If you want to make air circulate without any temperature control, follow these steps:
1. Set the MODE selector switch to “FAN” .
2. Press the ON/OFF ( ) button and switch the air conditioner ON.
FAN ONLY
ADJUSTING THE FAN SPEED
SLEEP MODE
The SLEEP mode enables you to save energy.
1. Set the MODE selector to cool, dry or heat.
2. Press the SLEEP button.
3. The mark appears on the display. Press the SLEEP button again to release
the SLEEP function.
What
does
the
SLEEP
mode
mean
?
In this mode, the air conditioner will cool or heat the room to the set
temperature. After about 1 hour, the air conditioner will automatically reset the
set temperature as follows (also refer to graphs).
OPERATING
MODE
SET
TEMPERATURE
CHANGE
Heating
Lowered
by
1
°
C
Cooling
and
Dehumidifying
Raised
by
1
°
C
