8
Through your wall
Further to your various ducting options, below are some
tips on how to correctly duct your rangehood:
– Always use correctly sized ducting
— DO NOT reduce the size of the ducting
– Always use solid ducting
– Always use non-flammable ducting
– Always duct to the outside atmosphere
– Do not use flexible ducting
– Do not duct into the ceiling space- always vent to the
outside atmosphere.
– Avoid sharp 90 degree bends as much as possible,
use 45 degree bends instead wherever possible
– Duct to the outside atmosphere using the shortest
duct run possible
– Use cylindrical ducting whenever possible
Positioning the rangehood
Installation heights
– Over gas and electric cookers,
Esatto
recommends our rangehoods to be mounted
at a height of between 600-800mm above the
cooking surface.
– Electric cooktops must have a minimum height of
600mm from the underside of the rangehood to the
cooktop face.
– Gas cooktops must have a minimum of 650mm from
the burner to the underside of the rangedhood.
– It is not recommended to install the rangehood
outside or over open flame grillers or barbecues.
–
Warning
Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards. The warning shall be in the same
part of the instructions that include details of how
to mount the equipment.
INSTALLATION INSTRUCTIONS
CONTINUED
After hanging the hood on the bracket, remove
the filters, mark 2 holes inside the hood for
safety screws. After marking, remove the hood,
drill two holes and insert 2 wall plugs and finally
fix the safety screws with 2 screws
(ST4x30mm)
（
Fig. 7
）
Place the plastic duct on the cooker hood.
（
Fig.
8
）
The lower chimney bracket is used to fix the
upper decorative chimney and lower decorative
chimney.
Use 2pcs 4x8mm screws to attach lower
chimney and lower chimney bracket together.
Put the lower chimney on the cooker hood and
mark the location of lower chimney bracket
fixing holes on the wall. Fix the lower chimney
bracket on the wall by 2 screws (4mm x30mm).
（
Fig. 9
）
Noted: Do not fasten screws too
much, make sure upper decorative chimney can
be telescopically adjusted after assembled.
Then pulling out the upper chimney upwards to
the target height. Adjust to reach the height
required. Fix the upper chimney on the upper
chimney bracket by 2 screws (4x8mm). Then
fix the upper chimney bracket on the wall.
Before fixing the bracket on the wall, you can
decide the upper chimney bracket fixing holes
for installation
（
Fig. 10
）
–
–
–
Drill 3 x 8mm holes to accommodate the bracket.
Screw and tighten the bracket onto the wall with
the screws & screw plugs provided.
（
Fig. 5
）
.
Level up the cooker hood and hang onto the wall
bracket hook.
（
Fig. 6
）
–
Installing the rangehood
–