7
Y
our Canopy Rangehood features
electronic switch
(Fig. 1) with
four
speed levels of extraction.
INSTALLATION REQUIREMENTS
Typical installation tools required
You’ll most likely require the following tools/equipment
(not supplied) for the installation of your rangehood.
– Electrical drill
– Tape Measure
– Screw-driver
– Spirit Level
If ducting your rangehood, you’ll also most likely require:
– Jig saw
– Ladder
– Duct-tape
– Ducting
Important installation safety notes:
– Always switch the power off prior to beginning the installation.
– Stainless steel is very easily damaged during installation.
Wherever possible, protect the rangehood with the cardboard
box or plastic
wrap during the installation.
– For safety reasons, this Rangehood must be earthed.
– A power point must be located within 1.5m of the power cord exit
from the rangehood, and it should be always accessible to allow
isolation from power during cleaning or maintenance.
– A 150mm round ducting adapter is supplied, however all other
ducting accessories are not.
– All ducting must comply with building codes and local
requirements.
– If you are re-circulating the air, rather than ducting, please ensure
that the side outlet grilles are not obstructed in any way as this
will affect the efficiency of the rangehood.
– Ensure that the rangehood is mounted in a level position,
both horizontally and vertically. This is essential to ensure the
rangehood operates correctly and prevents grease build up at
one end.
Lo
w
Mi
d
H
ig
h
Li
gh
t
Lo
w
Mi
d
H
ig
h
Li
gh
t
Lo
w
Mi
d
H
ig
h
Li
gh
t
WARNING!
All electrical work associated
with the installation of this
rangehood must be carried out
by a licensed electrician. This
rangehood must be correctly
installed by a suitably qualified
person in strict accordance with
all applicable rules and regulations
and following the instructions in
this manual.
—
Do not try to install
the rangehood yourself; doing so
will expose you to danger and void
the warranty. Improper installation,
adjustment, alteration or service
can cause injury or damage.
We decline any responsibility for
in jury or damage, to persons or
property, as a result of improper
installation.
Fig. 1
CONTROLS
– Push the ‘Low’ button, the
rangehood will operate at
low speed.
– Push the ‘Mid’ button,
the
rangehood will operate at a
medium speed.
– Push the ‘H
utton,
the
rangehood will operate at a
high speed.
–
Push the "
Turbo
" button and
the range hood will operate at
a highest speed. 5 minutes
working in this mode, the
rangehood would change to
3rd speed
automatically.
– To switch the rangehood
motor or light off, simply press
the button a second time.
T
urb
o
– Push the ‘Light’ button and
the two lights will come on. To
turn the lights off, simply push
the ‘Light’ button again.
T
i gh’ b
