8
Airvent UV-C FiltAir
Instruction Manual
Separately Packed Accessories
The UV-C lamps, screws, dowels and power cord can be found in
a seperate package inside the UV reactor. These must be removed
from the inside and placed in a safe place until the installation.
Remove the Filter
After turning the filter clamps, the filter can be tilted and re-
moved from the filter housing by reaching under the frame of
the filter.
Mounting the legs on the unit (optional accessory)
The removal of the filter
Preparing Mounting Holes
A)
Based on the Cardboard Template (Suggested Method)
The packaging consists of two identical corrugated cardboard
parts, which can also be used as a mounting template. On
the inside, marked points indicate where the mounting holes
should be drilled on the wall.
Size
C (mm)
UV-C FiltAir 15
400
UV-C FiltAir 30
600
UV-C FiltAir 45
600
UV-C FiltAir 75
1050
Place the template on the wall at the designated location of the
unit. Make sure that the template is meeting the floor, so the unit
will be installed at the right height. Mark the mounting points on
the wall with a sharp tool (e.g. a screwdriver or a fixing screw). After
removing the template, the boreholes can then be drilled in. In
the case of damaged packaging, the holes can also be made as
shown in the figure. The fastening dowels depend on the material
of the wall. The device is supplied with dowels suitable for fixing
to solid (eg concrete, brick) wall materials. In the case of other wall
constructions, a suitable fastening element must be used.
Packaging cardboards can be used as a mounting template
Ø10 4x
14
00
+
/–
2
37
5+
/–
2
C+/–2
