Appendix B
l
Replacing an ADCC module
Airvana ipBTS C30 Installation and Commissioning, Release 4.0
B-3
Figure B-2.
Module locking latch detail
Replacing an ADCC module
Use this procedure to replace an ADCC module in an ipBTS C30 shelf.
CAUTION
Replacing an ADCC module causes service disruption. Perform this procedure during a
maintenance window.
Tools required
To replace a radio module you will need the following tools:
•
#1 phillips-head screwdriver
•
SMA torque wrench
Procedure
To replace an ADCC card, do the following:
1. Use the #1 phillips-head screwdriver to fully loosen the captive screws on both sides of
the ADCC module (see
).
2. Pinch the locking latches (
) at the left and right sides of the module with your
thumbs and forefingers. Pull both latches out to pop the module away from the RN shelf
backplane.
3. Carefully slide the module out and put it aside.
Locking latches
Module top view
Summary of Contents for ipBTS C30
