AirTrack Factory AirBeam User Manual Download Page 7

7

www.airtrackfactory.com - [email protected] - Tel. +31 (0)24 89 09 659

These instructions apply to all inflatable equipment from AirTrack Factory that can be used at home as 

well as in a gym. 

 

Important

: This equipment is not a toy. It is professional training equipment for gymnastics, cheerleading, 

tumbling, school sports, showgroups, martial arts, parkour, freerunning and tricking.

USE EQUIPMENT ONLY FOR THEIR INTENDED PURPOSE

Personal

• This equipment is not suitable for children under  

 

   5 years.

• Do not allow more than one person at a time to 

 

   use the equipment.

• Do not wear shoes while on our equipment for 

 

   they may damage the surface.

• Do not jump or land closer than 20 cm to a valve.

• Consult an instructor prior to use.

• Use our equipment only under the supervision of 

 

   trained and qualified instructors.

• Use equipment with trained spotters and the 

 

   proper spotting equipment.

• Follow a progressive learning pattern. Assure 

 

   basic skills are achieved before attempting more 

 

   advanced skills.

Positioning and set-up

• Do not bring any sharp items on or close to the 

 

   equipment.

• Never place equipment near overhead 

 

   obstructions, such as low ceilings, trees or power 

 

   lines, nor place the equipment on a slope greater 

 

   than 5%.

• The area on which the equipment is placed  

 

   must be clean, dry, flat and free of obstacles and            

   walls.

• Always set up the equipment in the same area 

 

   where you will be using it. Do not drag or throw it. 

 

   Lift it by the handles and avoid scraping.

• Do not use the equipment in humid areas, 

 

   electrocution may occur.

Pressure

• Do not use a compressor. Use only inflation 

 

   equipment supplied by AirTrack Factory.

• Check the air pressure of the equipment       

 

   before each training session.

• Assure that the equipment has sufficient air 

 

   pressure to avoid bottoming out. Recommended 

 

   air pressure levels can be found in this user 

 

   manual.

• Use equipment only when all hard exposed 

 

   surfaces are protected with proper mats.

Outdoor

• When setting up the equipment outdoors,      

         

   use a groundsheet to avoid damaging the   

 

   equipment.

• Do not expose equipment to heat, including  

 

   heat from exposure to the sun.

• Never leave equipment outside unattended 

 

   and keep the air pressure under the maximum 

 

   values found in this guide.

• Do not use the equipment in the rain or snow. 

 

   While inflating equipment, electrocution may 

 

   occur and also the surface will be slippery which 

 

   can cause injuries.

• The equipment is not a flotation device.

Maintenance

• Never pack, store or transport the equipment 

 

   when it is moist or dirty.

• The equipment can be cleaned with water and 

 

   soft soap. Do not use industrial cleaning 

 

   products.

• Do not use the equipment when it’s damaged, 

 

   leaking or when parts are worn or missing.

Warnings

• Be aware that our equipment is not designed as 

 

   a landing mat.

• Equipment may move during use which could 

 

   result in serious injury.

• Serious injury (including permanent paralysis 

 

   or death) could result from any activity involving 

 

   motion, rotation or height.

• All users of this equipment assume this risk of 

 

   serious injury.

• Mats cannot and do not eliminate hazards.

SAFETY RULES

Summary of Contents for AirBeam













Reviews: