AirTight 60403 Operator'S Manual Download Page 4

NOTICE 

The ON/OFF button can be 

used to override the preset pressure  

value if required.

8. To operate lights, toggle switch from 

the “OFF” position to either the “Light”, 

“Flash” or “SOS” positions for desired 

lighting.

9. 

Unplug the power cord from 12V DC 

power outlet. 

P.O. Box 88259 Tukwila, WA 98138 • © 2011 Wilmar Corporation

All rights reserved • airTIGHT™ is a trademark of Wilmar Corporation

TROUBLE SHOOTING

INFLATOR DOES NOT WORK WHEN 

SWITCHED TO “ON” 

• Power cord may not be plugged in 

completely. Check the connection.

• Check vehicle power outlet and power 

plug terminals for dirt. Use a non-

conductive probe, not fingers or metal, to 

clean.

• Check to see if the pre-programmed 

pressure is set to a lower PSI than your 

tire currently is reading (i.e., the digital 

gauge is set to 15 psi but your tire is at 

2o psi; in this scenario, the inflator will 

not turn on) Refer to the digital gauge 

operating instructions and set the PSI to 

the correct tire pressure.

• Check vehicle power outlet fuse, which 

should be a minimum of 15 Amps.

• Fuse may have blown. Check fuse in 

power plug adaptor and replace if 

necessary with one of the same 

amperage. NEVER replace a blown fuse 

with a fuse having a higher rating.
UNIT IS RUNNING BUT TIRE IS NOT 

INFLATING 

• Check that the air hose connector is 

attached properly to the tire valve stem. 

• Check for tire leaks or damage, and 

check air hose for breaks and leaks at 

fittings.
INFLATOR FEELS HOT OR RUNS 

SLOWLY

• Unit may have overheated. Shut the unit 

off and allow to cool for 20-25 minutes.

• NEVER use this inflator for more than 

10 minutes continuously.

• Voltage may be too low. Check 

condition of vehicle battery.

Reviews: