Airstream Sport 2017, Owner'S Manual

Page: 44 / 90

Interior
5-16
2017 Sport
the display will immediately switch to show the
new level or voltage� The 5 second time-out is
restarted every time a button is pressed�
3� To continuously display a reading, press and
release the desired button, and then press the
same button a second time� When the button is
released, the display will be on hold mode, which
is indicated by the decimal point on the right hand
side turning on� While the display is in the hold
mode it will recheck the level once per second
so the user can watch the level change while
the tank is being filled or drained. The display
will automatically shut off after 5 minutes in hold
mode� To end the hold mode before the 5 minutes
is up, press any tank button, and the display will
shut off�
To Read the Battery Voltage
1� Press the BATT button and release it, the display
will show the battery voltage on the LED display
2� If no other button is pressed, then the display will
shut down after about 5 seconds� If the BATT
button is held down, the display will continuously
recheck the voltage and show the updated value�
The reading may flicker back and forth between
two values�
3� If another button is pressed before the 5 second
time is up for the BATT button, the display will
immediately switch to show the value for the new
button� The 5 second time-out is restarted every
time a button is pressed�
4� There is no hold mode for the battery voltage
To Program the LED Brightness
1� The display needs to enter the brightness
programming mode� To do this, press and hold
the BATT button; the display will show the battery
voltage�
2� While continuing to hold the BATT button, press
and hold the GREY button� Continue to hold
both buttons for approximately 5 seconds until
the display shows “bri” to indicate the brightness
programming mode� When this occurs, release
both buttons�
3� Press the GREY tank button to increase
brightness, or the FRESH tank button to decrease
brightness
4� When the display shows the correct brightness,
press the BATT button to exit the programming
mode�
SeeLevel II Monitor Panel
The display is the only system component that is
accessed by the user� All user input to the display is
done using the four buttons along the bottom of the
display�
NOTE
The 16’ Sports combination Black/Grey tank
requires only the “Black” button to be pressed to
view the current tank level. Pressing “Grey” will
result in “OPn” being displayed.
The display receives the information from the three
sender pads via a single, two-conductor wire, and
displays the level information in percent of full on a
three-digit, LED display� When the front panel button
for a particular tank is pressed, the display powers
up and displays the level for that tank� If the button
is pressed and released, the display will show the
level for about 5 seconds and then shuts down
automatically� If another button is pressed before the
display shuts down, then the new level will immediately
be shown� If the same button is pressed twice, the
display will hold on that tank and continue to show
updated levels for 5 minutes before shutting off� This
allows the user to monitor the filling or draining of the
tank� By pressing two buttons at once, the diagnostic
functions can be accessed�
Sender pads are installed and stuck to the sides of
the holding tank� Sender pads can be cut to match
the height of the tank, it also auto calibrates itself
so it can read from empty to full� The sender pad
scans the water level through the tank wall using
digital techniques programmed into the sender
microprocessor�
To Read a Water or Sewer Tank Level
1� Press the button corresponding to the tank to be
checked and release it, the display will show the
levels in percent on the LED display� If no other
button is pressed, then the display shuts off after
about 5 seconds�
2� If another button (including BATT) is pressed
before the 5 second time is up for the first button,