Airspan AirSynergy3, Installation Manual

Page: 5 / 65

AirSynergy3 Equipment Installation Guide
Page 5 | Commercial in Confidence SYN-UG-018

Summary of Figures
Figure 1
– Typical AirSynergy with sun shield
............................................................................... 11
Figure 2
– AirSynergy with front sector antenna fitted
................................................................... 11
Figure 3
– AirSynergy with Switched Beam Antenna
...................................................................... 12
Figure 4
– AirSynergy dual radio configuration
............................................................................... 12
Figure 5
– Workflow of AirSynergy Installation
.............................................................................. 13
Figure 6
– AirSynergy unit in typical packing box as supplied with foam inserts
....................... 19
Figure 7
– Single radio AirSynergy unit (connectorised)
.............................................................. 19
Figure 8
– Dual Radio Synergy (Can be any combination of 2 x connectorised or 1 x
connectorised and 1 with SBA) ......................................................................................................... 19
Figure 9
– Single radio AirSynergy unit with Switched Beam Antenna (factory fitted)
............... 19
Figure 10
– Universal Mounting Plate and pole straps
.................................................................. 20
Figure 11
– Sun Shield with fixings
................................................................................................... 20
Figure 12
– Sector Antenna Mounting plate and fixings
................................................................. 20
Figure 13
– Sector Antenna (Check frequency variants)
................................................................ 20
Figure 14
– PSU
................................................................................................................................... 21
Figure 15
– Enclosed PSU (US requirement)
................................................................................... 21
Figure 16
– GPS antenna
.................................................................................................................... 21
Figure 17
– GPS antenna mounting kit
............................................................................................. 21
Figure 18
– AirSynergy mounting plate and fixings
...................................................................... 22
Figure 19
– Feed clamp bands through the quick release locking mechanisms
........................ 22
Figure 20
– Press down the locking mechanism with the slack band fed through
..................... 23
Figure 21
– Tighten clamps with large flat blade screwdriver
........................................................ 23
Figure 22
– AirSynergy mounting plate installed (large diameter concrete pole)
........................ 23
Figure 23
– Fixing the front mount antenna to the mounting plate
............................................... 24
Figure 24
–Fitting the Front mount antenna assembly to AirSynergy
.......................................... 24
Figure 25
–Fitting the GPS antenna to the mounting bracket
........................................................ 25
Figure 26
–GPS antenna cable connected
....................................................................................... 25
Figure 27
– Assembling the GPS antenna and bracket assembly to AirSynergy
........................ 26
Figure 28
– Lift AirSynergy to top of pole-mount plate
.................................................................. 26