7
STRUCTURE & DESCRIPTION
CONTROLLER
1. LED DISPLAY
It displays the status of temperature, time, operation,
and error, etc.
2. TIMER DISPLAY
It displays remaining time at the Timer off mode.
3. TEMPERATURE CONTROL MODE
It is lighten at the temperature control mode.
4. TIME CONTROL MODE
It is lighten at the time control mode.
5. IR RECEIvER FOR REMOTE CONTROLLER
It receives signal from remote controller.
6. ON / OFF
Run and stop BUTTON
7. TEMP/TIME CONTROL SELECTION BUTTON
To select temperature or time control mode.
8. UP/DOWN
To set or change the temperature or time.
9. OFF TIMER
You can timer off for 30 minute ~ 24 hours by
30minutes term.
To release press this switch for 1 second, then off timer
mode will be released.
10. OFF TIMER LED
To show whether timer off mode is operating or not.
11. FUEL GUAGE DISPLAY
It displays fuel remain in 5 steps. when it become
<refuel> the lamp will be flickering and buzzing 20 times.
12. MISFIRE
It shows the misfire on the burner.
13. OvERHEATING
It shows overheating status if the temperature goes up to
105℃. This sensor is recovered automatically.
14. TILT SENSOR
It is turned on in case of inclination over 30deg. or an
excessive motion is detected.
15. LACk OF FUEL :
If the heater is running after buzzing of <<refuel>> without
filling fuel, it becomes <<lack of fuel>>.
16. OPERATION LAMP
It is lighten on operation.
17. BUzzER
In case various errors are detected or fuel is almost
runned out.
1
2
6
7
13
14
15
17
16
3
4
5
8
10
11
12
9
