AirPicnic APN212, User Manual

Page: 8 / 29

mer set
-off
r button when the unit is on. The LED will flash_ _five
from
2
n check remnant time by pressing Timer button. It
3.Set timer-on
button when the unit is off. Same as timer-off set. Once the
Cooling/Heating and Dehumidifying operation
.Cooling/Heating operation
OPERATION METHODS
Ti
1.Set timer
Press the Time
Times. During this period press Up or Down button to adjust set time
0.5h to 24h. It will vary 0.5h each time in 3h and 1h each time hereafter. The
set time will flash 5 times after adjusting. When it will display temperature
again. Once the set time end, the unit will turn off automatically.
. Change the set time
When Timer is on, you ca
will flash 5 times. Press Up or Down button to adjust set time. The set time
can also be cancelled if you press the Timer button once again during the
flashing time
.
Press the Timer
set time end, the unit will turn on automatically.
1
Press Mode button or / to choose Cool/heat mode.
n o Press Up or Down butto r to set a proper room temperature.
F). Th se The range is 18~30
℃
(64-86
°
e temperature will increase or decrea
1
℃
or 1
°
F each time.
Press Speed button or to choose a proper fan speed.
Press Swing button or t d t the direction of vertical louver. o a jus
2.
Adjust horizontal louver by hand.
Dehumidifying operation
Press Mode button or to choose Dry mode. The fan speed is Low,
N
l mode, when the water Injection indicates lights, you can inject
with the drainpipe in heat and dehumidifying
LED displays room temperature. These cannot be adjusted.
OTE:
1. In coo
some water through the injection port before cooling operation (no
longer than High level).
2. You should drain water
mode. The unit will stop work when water level exceeds the high level.
3. Do not use air exhaust duct when in Dry or Fan modes
7