Hardware
Installation
1
Quick
Installation
Guide
6
www.netkrom.com
4.
Screw the entire feedthru assembly into the RJ45- ECS housing
which is already mounted in the enclosure. There should be a
rubber gasket between the two assemblies. Tighten the
feedthru assembly to create a seal.
5.
The final step is to tighten the compression nut until the gaskets
are tight around the Cat5 cable. Always push the cable toward
the connector while tightening to ensure good strain relief of
cable to connector.
Step 2:
Connect the external antenna to the N Female connector of the
Access Point.
Screw in the Coaxial cable connector correctly into the antenna
connector (N-Female) located on the Outdoor Access Point case.
Make sure the former line is properly done and cover the N
connectors with an insulating tape.
RJ-45 ECS Housing
High Capacity Wireless Networks
300 Mbps
GIGA1000 SERIES
Summary of Contents for AIR-BR1000AGN
Page 19: ...300 Mbps GIGA1000 SERIES...